如果你遇到了卷簾門鑰匙燈亮但門打不開的情況，不妨先來看看下面所講解的內容，說不定問題就能解決了。

If you encounter a situation where the key light of the roller shutter door is on but the door cannot be opened, you might as well take a look at the contents explained below, and the problem may be solved.

鑰匙電量不足

The key power is low

若濟南卷簾門的遙控器鑰匙的燈有亮，但是卷簾門還是打不開的話，那么有可能是因?yàn)榫砗熼T(mén)遙控器鑰匙的電池的電量不足了導致的，這時只需要更換一個新的電池就可以了。

If the light of the remote control key of Jinan roller shutter door is on, but the roller shutter door still cannot be opened, it may be because the battery of the remote control key of the roller shutter door is low. At this time, it only needs to replace a new battery.

鑰匙距離太遠

The key is too far away

若卷簾門的遙控器鑰匙的燈有亮，但是卷簾門還是打不開的話，也有可能是因?yàn)榫砗熼T(mén)的遙控器鑰匙距離卷簾門太遠了導致，這時只要靠近卷簾門一些就可以了。

If the light of the remote control key of the roller shutter door is on, but the roller shutter door still cannot be opened, it may also be because the remote control key of the roller shutter door is too far away from the roller shutter door. At this time, just close to the roller shutter door.

遙控器電路板老化

Remote control circuit board aging

若卷簾門的遙控器鑰匙的燈有亮，但是卷簾門還是打不卡的話，也有可能是因?yàn)榫砗熼T(mén)遙控器內部的電路板出現了老化現象導致的。電路板一旦老化的話，必然就會導致遙控器出現遙控失靈的現象，這時只要把卷簾門遙控器拆開清洗一下就可以了。

If the light of the remote control key of the roller shutter door is on, but the roller shutter door still does not open, it may also be caused by the aging of the circuit board inside the roller shutter door remote control. Once the circuit board is aged, it will inevitably lead to remote control failure of the remote control. At this time, just disassemble the remote control of the roller shutter door and clean it.

遙控器電路板損壞或掉碼

The circuit board of the remote control is damaged or the code is lost

假如是因?yàn)榫砗熼T(mén)遙控器內部的電路板出現了損壞導致卷簾門打不開的話，那么就需要更換一個新的卷簾門遙控器。假如卷簾門遙控器有出現掉碼現象的話，也容易導致卷簾門打不開，這時就需要請維修人員上門幫忙維修。

If the shutter door cannot be opened due to the damage of the circuit board inside the shutter door remote controller, then a new shutter door remote controller needs to be replaced. If the remote control of the roller shutter door drops the code, it is also easy to cause the roller shutter door to fail to open. At this time, it is necessary to ask the maintenance personnel to help repair.

遙控器失靈

Remote control failure

卷簾門的遙控器鑰匙的內部一般都會有一個接觸器，或者是有配置一個電動開關，一旦這些配件出現問題的話，就容易導致卷簾門的遙控器鑰匙出現遙控失靈的現象，這時就需要把卷簾門的遙控器鑰匙的內部出現損壞的配件更換成新的。

Generally, there is a contactor or an electric switch inside the remote control key of the roller shutter door. If these parts are faulty, it is easy to cause the remote control failure of the remote control key of the roller shutter door. At this time, it is necessary to replace the damaged parts inside the remote control key of the roller shutter door with new ones.

卷簾門在打開或者是關閉的時候，有時會出現轉不動或者是轉動很慢的現象，這種現象一般都是因?yàn)榫砗熼T(mén)負荷太重了導致的，或者是因?yàn)榫€路被燒斷了導致的，這時就需要詳細檢查一下電路情況，并且要把通向卷簾門的電路接通，或者是把卷簾門堵住的物品清理干凈。更多使用事項就來我們網站http://98am111.com進行咨詢了解吧！

When the roller shutter door is opened or closed, sometimes it can not turn or turn very slowly. This phenomenon is usually caused by the heavy load of the roller shutter door, or by the burning of the circuit. At this time, it is necessary to check the circuit condition in detail, and connect the circuit leading to the roller shutter door, or clean up the articles blocked by the roller shutter door. Come to our website for more usage matters http://98am111.com Consult and understand!